The custom sweep is quite similar to the cyclic sweep technique except that user defined sweeps can be constructed with delays and re-offsets. A custom sweep is constructed from Nodes to add a Node click one of the available Components:
Sweep
A sweep from a start to a finish potential at a defined sweep rate or sweep length.
A positive current limit can be imposed when reached the test can either move onto the next node or the test can be finished.
Delay
A delay for a predefined length of time either coupled to or isolated from the cell. If the delay is coupled the cell potential is held at the last set potential - normally the finish potential of the previous sweep node or an offset potential (see below).
If the cell is isolated there is an option to end a delay if the cell potential passes a set potential.
Offset
The offset can be used to set a potential before a delay or to re-measure and re-offset to the rest potential before a sweep node.
Using Over sample measurements greatly improves the smoothness of recorded data many readings are averaged for each point.
