Potential Measurement only serves a purpose if it is placed within a long term folder this is because the technique only gives a potential result and does not shown any graphical data it’s self. There is only one setting for potential measurement - Measurement averaging the actual averages taken for each setting are as follows:
Measurement Averaging |
Number of Averages |
Normal |
20 |
High |
40 |
Very High |
60 |
Long Term - Galvanic Measurement
Galvanic Measurement should only be placed within a long term folder. Measurement averages are the same as the potential measurement table above.
Couple Aux Electrode to WE2 allows 3 electrode cells to record galvanic measurements the AE connection normally used to polarise the test can be switched to act as WE2 so WE2 does not have to be connected.